How-to attach finishes to my ICF Walls
So you have your Advantage ICF foundation or above grade walls installed and poured, now the question is how to finish it? Below one of our Advantage team members discusses how to apply finishes to your ICF walls….
Drywall is fastened to an Advantage ICF wall the same way as it would be in a wood frame house except that I recommend you use drywall screws rather than nails. When you screw it on make sure you hit one of the plastic webs or ties spaced at 8” on center for 6” ICF walls or 6” on center for 8” ICF walls. Typically a standard stud finder will find these ties as it would normal wood studs. I would recommend using a little longer than normal drywall screw with a coarse thread pattern.
Note: that an indented line marks all Advantage ICF System blocks at 25.4 mm (1”) intervals to simplify measuring and marking. Double lines mark web locations.
What types of fasteners are required for drywall?
Wall coverings can typically be attached to the ties or webs in your ICF system with #6 or #8 Type W (coarse thread) drywall screws. The screws must be corrosion resistant and have a sufficient length to penetrate the plastic tie or web a minimum of ¼” (6.4mm). #6 Type W drywall screws will provide an allowable pull-out capacity of 36 lbs (160 N) and an allowable lateral load capacity or 66 lbs (294 N). #8 Type W drywall screws will provide a slightly higher allowable pull-out capacity of 44 lbs (196 N) and an allowable lateral load capacity or 98 lbs (436 N).
What about stucco?
Conventional stucco is applied by attaching the wire straight to the ties or webs with pan-head screws. Acrylic stucco manufacturers may require only typical foam preparation and the application directly onto the surface of the ICF with no stucco wire.
What about Siding?
Horizontal joints: strapping between the ties or webs using metal banding may be required if the siding joints line up with the joints in the block (where there are not ties or webs)
J trim: bucks may have to be modified to allow for certain types
Corners: strapping around corners with metal banding may be necessary for certain corner moldings. Use screws to install all sidings.
Note: All interior ICF surfaces must be covered by an acceptable thermal barrier. Exterior finishes and application requirements may vary based on local code requirements.
Basically anything that can be used as an exterior or interior finish on a conventional home can also be used with the Advantage ICF system. Want to learn more? Visit the Advantage web site for more information.